top of page
Search

Premise Backflow Install: Make Sure Irrigation Is Downstream of the Device

nashbrienza
Oct 26
1 min read

Here's a detail that gets missed on a lot of installs: where the irrigation line ties in.


On a premise backflow install, the device protects everything downstream of it — the whole building. That only works if every water use, including irrigation, is actually downstream of the device. If the irrigation line branches off before the premise preventer, that water has no protection at all.


And irrigation is one of the higher-risk uses in a building. Fertilizer and chemicals sit in those lines, and a pressure drop can pull that water back toward the drinking supply. That's exactly what the premise device is there to stop — but only if the irrigation is on the protected side of it.


On this install, the irrigation tie-in is downstream of the premise device, so the whole building — irrigation included — sits behind the protection. A Watts expansion tank on the downstream side takes care of thermal expansion now that the system is closed. The device was tested and tagged, as always.


If you're not sure where your irrigation ties in, it's worth a look. It's a small detail with a big consequence.


Van Horne Plumbing and Backflow — backflow testing, repairs, and cross-connection surveys across the GTA.

 
 
 

Comments


Vanhorne Plumbing & Backflow Powered and secured by Wix

bottom of page